#include <string.h>
#include <stdarg.h>
#include "board.h"
#include "datasheet.h"

//------------------------------------------------
//    Board
//------------------------------------------------

void board_init(void)
{
  //Init boost regulator control (NOTE: 1V-BAT logic level)
  GPIO_INIT_PIN(BOOST_EN, OUTPUT, PID_GPIO, 0, GPIO_POWER_RAIL_1V );

  // Init LEDs
  GPIO_INIT_PIN(D0,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D1,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D2,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D3,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D4,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D5,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D6,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D7,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D8,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D9,  OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D10, OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(D11, OUTPUT, PID_GPIO, 1, GPIO_POWER_RAIL_3V );

  //SPI
  GPIO_INIT_PIN(ACC_SCK, OUTPUT,          PID_GPIO, 1, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(ACC_SDA, INPUT_PULLDOWN , PID_GPIO, 0, GPIO_POWER_RAIL_3V );

  //UART
  GPIO_INIT_PIN(UTX, INPUT_PULLUP, PID_GPIO, 0, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(URX, INPUT_PULLUP, PID_GPIO, 0, GPIO_POWER_RAIL_3V );

  //OTHER
  GPIO_INIT_PIN(CAPI,     INPUT_PULLDOWN, PID_GPIO, 0, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(CAPO,     INPUT_PULLDOWN, PID_GPIO, 0, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(NC_P12,   INPUT_PULLDOWN, PID_GPIO, 0, GPIO_POWER_RAIL_3V );
  GPIO_INIT_PIN(NC_P13,   INPUT_PULLDOWN, PID_GPIO, 0, GPIO_POWER_RAIL_3V );
}